T-Rex 600

HFX

(HeliFreak Xtreme)

HFX Kits Feature

• Top mounted motor to allow a better 3D Flight Characteristics without trimming your canopy
• Lowered frame height by nearly 1” raising axial CG
• Uses standard size servos with direct  linkage CCPM for faster response and to save weight also complexities
• Ball raced servo bridges to remove unwanted servo shaft deflection under high loads
• Positive lock G-10 main shaft bearing blocks to allow a compact servo layout
• Adjustable servo arm adapters that allow you to achieve a zero sub trim setup
• Break away canopy pin tabs to help reduce costly frame breakage
• Optional top mounted receiver tray to raise CG and the need for excessive use of servo wire extensions
• Open frame design allows easy access to your electronics and installation of long battery packs
• Redesigned critical stress areas of known break points on stock frame
• Frame doubler for better frame rigidity between pinion and main gear
• Press in nuts for a frustration free servo install no more plastic servo mounts
• Slots for Velcro straps in battery area and on top of boom mount .
• Wire zip tie slots for wires and ESC.
• Carbon Fiber panel thickness is 1.65mm, G-10 is 1.7mm